Contents: Removal ⇓ Installation ⇓
Removal
1. Remove the clutch sleeve and the air conditioning compressor pulley.
2. Install the safety tool on the open hole of the compressor shaft.
3. Install the puller on the compressor as shown in the figure. Insert the tip of the pressure screw into the recess of the compressor shaft safety tool and tighten the puller screw.
4. Using a wrench to tighten the puller screw, remove the coil from the front of the compressor.
Warning! Do not use pneumatic tools.
Installation
1. Clean the clutch excitation coil.
2. Place the compressor vertically with the shaft facing up and install the clutch exciter coil on the front of the compressor. Make sure the coil electrical connector is positioned correctly.
3. Install the safety tool on the open hole of the compressor shaft.
4. Install the coil pressing tool along the inner radius of the excitation coil.
5. Tighten the tool screw with a wrench until the coil is in place.
6. Install the clutch sleeve and air conditioner compressor pulley.