When connecting the pipe and hose, make sure to align the white marks on each element.
Pressure hose and pipe
1. Remove the air intake pipe.
2. Remove the pressure hose mounting clamp.
3. Disconnect the pipe fitting from the steering gear side.
4. Raise the vehicle and remove the clamp securing the pressure and return pipes.
5. Lower the vehicle and remove the connector (24mm).
6. Remove the pressure hose and tube.
7. Installation is carried out in the reverse order of removal.
- 1. Install the pressure hose and tube so that they are not twisted and do not touch moving parts of the vehicle.
- 2. Bleed the power steering hydraulic drive.
Return hose and pipe
1. Remove the power steering fluid reservoir from the bracket.
2. Remove the return pipe and hose mounting clamps.
3. Remove the air intake pipe.
4. Disconnect the pressure pipe and return pipe fitting from the steering gear.
The original source of the article is the website [hyundaibook]
5. Raise the vehicle and remove the clamp securing the pressure and return pipes.
6. Lower the vehicle and remove the return pipe and hose retaining clamp.
7. Installation is carried out in the reverse order of removal.
- 1. Install the return hose and tube so that they are not twisted and do not touch moving parts of the vehicle.
- 2. Bleed the power steering hydraulic drive.
Examination
1. Manually twist the hose to check for damage or cracks.
2. Make sure that there is no contact between the hose and other parts of the vehicle.