Removal
1. Drain the coolant and disconnect the radiator outlet hose from the coolant pump.
2. Remove the drive belt from the pump pulley.
3. Remove the timing belt covers and its tension pulley.
4. Loosen the pump mounting bolts and remove the generator adjusting bar.
5. Remove the pump from the cylinder block.
Examination
1. Check each part for cracks, damage and wear and replace the coolant pump if necessary.
2. Check the bearings for damage, increased noise and difficult rotation and replace the pump if necessary.
3. Check for coolant leakage. If coolant leaks from port A, the seal is damaged. Replace the coolant pump.
Installation
1. Clean the gasket-facing surfaces of the coolant pump and cylinder block.
2. Install the new pump gasket onto the pump and tighten the bolts to the specified torque.
The original text is available on the website [www.HyundaiBook.ru]
Tightening torque: Pump to cylinder block - 12-15 Nm
3. Install the timing belt and its tension pulley and adjust the timing belt tension.
4. Install the timing belt covers.
5. Install the pump pulley and drive belt, then adjust its tension.
6. Fill the system with clean coolant.
7. Start the engine and check for leaks.
