Contents: Removal and inspection ⇓ Installation ⇓
Removal and inspection
1. Drain the coolant to the thermostat level or below.
2. Remove the coolant inlet pipe and gasket.
3. Remove the thermostat.
4. To check the valve opening temperature, immerse the thermostat in hot coolant. Replace the thermostat if necessary.
- Valve opening start temperature is 82°C
- Full valve opening temperature is 95°C
- Valve lift (fully open) - 8.5 mm or more
[The original article is posted on the portal: hyundaibook.ru]
Installation
1. Check that the thermostat flange is seated correctly in the thermostat housing socket.
2. Install the new gasket and coolant inlet pipe.
3. Fill the system with clean coolant.