Contents: Removal ⇓ Installation ⇓
1. Vacuum hose; 2. Check valve; 3. Cotter pin; 4. Gasket; 5. Hinge pin; 6. Vacuum booster; 7. Master brake cylinder; 8. Brake fluid level sensor
Removal
1. Disconnect the vacuum hose (1) from the booster (2). Remove the brake master cylinder (3).
2. Remove the cotter pin (4) and take out the hinge pin (5). Unscrew the four reinforcement nuts (6). Tightening torque: 13-16 Nm.
The original material is located on the website (www.hyundaibook.ru)
3. Remove the vacuum booster (7) from the engine compartment.
Installation
4. Adjust the length of the push rod (A), then install the gasket. Nominal value: 116.3±0.5 mm.
5. Further installation is carried out in the reverse order of removal