Attention: bleeding the hydraulic brake system of vehicles equipped with an anti-lock braking system (ABS) should only be carried out at specialized service stations.
1. Remove the brake fluid reservoir cap and add fluid up to the "MAX" mark.
Caution: Do not allow brake fluid to come into contact with painted surfaces of the vehicle body or exposed skin.
2 Connect a transparent tube to the wheel brake cylinder valve. Place the other end of the tube in a transparent container filled 1/2 full with brake fluid.
3. Start the engine.
4. Slowly press the brake pedal several times. While holding the brake pedal down, loosen the valve and tighten it after the brake fluid stops flowing out.
5. Repeat step 4 until the brake fluid starts to flow out without air bubbles. Tighten the air bleed valve. Tightening torque: 7-13 Nm.
6. Bleed the remaining wheel cylinders in the order shown.
7. Add brake fluid to the reservoir up to the "MAX" mark.