Contents: Removal ⇓ Installation ⇓
1. Screw; 2. Anchor disk; 3. Washer; 4. Fastening ring; 5. Pulley; 6. Retaining ring; 7. Electromagnetic clutch; 8. Screw; 9. Bracket; 10. Compressor; 11. Collector; 12. Screw; 13. Gasket
Removal
1. Start the engine and let it idle for a few minutes.
2. Stop the engine and disconnect the cable from the negative terminal of the battery.
3. Remove the refrigerant from the air conditioner.
4. Remove the compressor drive belt.
5. Unscrew the nuts and disconnect the feed (1) and pressure (2) tubes from the compressor. Seal the compressor channels with plugs (3).
6. Disconnect the electromagnetic clutch connector (4).
7. Loosen the screws and remove the compressor.
8. Install the compressor and tighten the mounting screws in the sequence A→B→C→D.
| Screw | Screw length, mm | |
| Gasoline engine | Diesel engine | |
| A | 132 | 109 |
| IN | 132 | 100 |
| WITH | 100 | 100 |
| D | 100 | 100 |
Installation
9. Further installation is carried out in the reverse order of removal.