2. Loosen the manual control lever flange nut to release the cable and lever.
3. Set the manual control lever to the "N" (neutral) position.
4. Rotate the transmission switch housing until the 12mm wide end of the manual control lever aligns with the switch housing flange (12mm wide section).
5. Tighten the mounting bolts to the specified torque.
- Gearbox switch mounting bolt - 10-12 Nm
Note: When installing the switch housing, make sure that the sealing ring does not fall off the housing.
6. Make sure the shift lever is in the "N" (neutral) position.
7. Adjust the flange nut so that there is no play in the control cable and make sure that the shift lever moves smoothly.
8. While the vehicle is moving, make sure that all gears in the gearbox are engaged when the shift lever is moved to each position.