Adjusting the downshift servo (Hyundai Accent X3)

1. Completely remove dirt and other contaminants around the servo switch.

2. Remove the snap ring.



3. Loosen the adjusting screw two turns and then finally tighten to a torque of 5 Nm.

4. Tighten the adjusting screw to a torque of 5 Nm, then loosen the adjusting screw by 3-3⅓ turns.

5. Tighten the lock nut to the required torque (15-22 Nm).

Note: Apply the required amount of grease before assembly (DC780) on the adjusting screw.