Removal air (Hyundai Accent X3)

1. Disconnect the high-tension wire from the ignition coil side and, while operating the starter in intermittent mode (15-20 s), turn the steering wheel to the left, then to the right 5-6 times.

Warnings:

• 1) When removing air, add liquid so that the liquid level does not fall below the filter position.
• 2) If air is removed while the engine is idling, the fluid will absorb the air entering the system. Therefore, air should only be removed while the crankshaft is turning.

2. Connect the high voltage wire, start the engine.

3. Turn the steering wheel right and left; until air bubbles disappear from the oil reservoir.

Warning: Once you have turned the steering wheel all the way to the right or left, do not hold it in this position for more than 10 seconds.

4. Check: the liquid should not be cloudy and should reach a certain level.

5. When the steering wheel is turned left and right, there should be a slight change in the fluid level.