Contents: Removal ⇓ Installation ⇓
1. The pin securing the rod to the clutch pedal
2. Washer
3. Cotter pin
4. Master cylinder rod
5. Dust cover
6. Retaining ring
7. Thrust washer
8. Piston
9. Spring seat
10. Spring
11. Body
12. Sealing ring
13. Fitting
14. Screw
15. Hose
Removal
1. Drain the working fluid from the hydraulic drive through the valve (1).
2. Remove the cotter pin (2) with the washer (3) and remove the axle pin (4).
Note: Apply grease to the pin (4) before installation.
3. Disconnect the master cylinder push rod (5) from the clutch pedal.
4. Disconnect the tube (6) from the master cylinder. Nut tightening torque: 13-17 Nm.
 |
 |
5. Disconnect the master cylinder hose (7) from the brake fluid reservoir.
6. Unscrew the mounting nuts under the instrument panel and remove the master cylinder. Tightening torque: 9-14 Nm.
Installation
7. Installation is carried out in reverse order.
8. Bleed the clutch hydraulic drive.