1 - intake manifold; 2 - bolt, 15–20 Nm; 3 - throttle assembly; 4 - bolt, 15–20 Nm; 5 - gasket; 6 - fuel line; 7 - air compensation chamber.
Withdrawal
1. Disconnect the connectors from the air flow and throttle position meter sensors.
2. Remove the air inlet connected to the throttle assembly.
3. Remove the accelerator cable.
4. Remove the crankcase ventilation hose and brake booster vacuum hose.
5. Disconnect the vacuum hose connections.
6. Remove the airbox support.
7. Remove the airbox and gasket.
8. Disconnect the wiring harness connector from the fuel injectors.
9. Remove the fuel line with fuel injectors.
Warning! Be careful not to drop the fuel injectors when removing the fuel line.
10. Remove the insulator from the intake manifold and disconnect the heater hose.
11. Remove the intake manifold.
Examination
1. Check the air chamber for defects or cracks.
2. Check intake manifold for damage or splitting of any part.
3. Check the air tube for damage or splitting of any part.
Installation
1. Install the fuel line with the fuel injectors attached to it.
Warning! Be careful not to drop the fuel injectors when removing the fuel line.
2. Check that the insulators are correctly inserted into the holes in the fuel line.