Remove the tie rod end.
Loosen the clamps at both ends of the cuff, remove the rubber cuff.
Installation
Apply grease to the steering rod (3).
(The original text is located on the portal: «www.HyundaiBook.ru»)
Treat the inside of the sealing area (2) with silicone grease (5) and place the sealing area on the steering rod (3).
Secure the cuff at the rack housing (1) and at the steering rod (3) with clamps (4) so that the cuff does not twist.
Install the tie rod end.
Lower the car.
Check and adjust the toe-in.