Replacement of working fluid (Hyundai Tucson JM)

1. Raise the front of the vehicle until the wheels are off the ground and place it on stands.

2. Disconnect the drain hose from the hydraulic drive reservoir and plug the reservoir opening.

3. Attach a vinyl hose to the drain hose and lower its end into the prepared container.

4. Disconnect the high-voltage wire from the ignition coil. Drain the fluid from the system by turning the starter on and off several times and turning the steering wheel in both directions until it stops.

5. Connect the drain hose to the tank and secure it securely with a clamp.

6. Pour 0.75-0.8 l of PSF-3 fluid into the power steering reservoir.

7. Start the engine. Make sure there is no fluid leakage through the hose connection and stop the engine

8. Add fluid to the bottom of the power steering reservoir filter.

9. Remove air from the system.