Replacing the drive shaft oil seal ring (Hyundai Elantra XD)

Procedure

1. Disconnect the drive shaft from the gearbox.

2. Using a flat-head screwdriver, remove the sealing ring from the gearbox socket.

3. Using drift 09431–21200, install a new O-ring into the transmission housing seat.

4. Lubricate the working edge of the new sealing ring with oil.

The original article is posted on the portal: HyundaiBook.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Elantra 3: Automatic gearbox

Adjusting the pressure in the line (A4AF3)
Adjusting the forced downshift servo (A4AF3)
Identification of bearings of automatic transmission F4A43
Malfunction Indicator Lamp (MIL)
Identification of bearings of automatic transmission F4A42

Removal and installation of the F4A42 gearbox
Removal and installation of gearbox A4AF3
Automatic transmission control
Installing a blocking device
Installing a key lock device

We recommend other articles on the topic of Hyundai manuals: