Contents: Glass replacement ⇓ Servo Motor Replacement ⇓ Replacing the hatch assembly ⇓ Replacing the guides ⇓
Glass replacement
1. Close the sunroof completely. Pull the sunshade back.
2. Remove both decorative trims (A).
3. Lift and remove the sunroof glass.
4. Stopping is carried out in the reverse order of removal. After installation, check for leaks.
Servo Motor Replacement
1. Remove the upper console.
2. Disconnect the plug (A), loosen the mounting screws (B) and remove the servo motor.
[The material is republished from the web portal: www.hyundaibook.ru]
3. Installation is carried out in the reverse order of removal.
Replacing the hatch assembly
1. Remove the center, front and rear pillar trims, then remove the roof trim and sunroof glass.
2. Disconnect the drain tubes (A).
3. Loosen the mounting bolts and nuts, then remove the roof hatch assembly (B).
Note: When removing the sunroof, be careful not to damage the interior trim.
4. Installation is carried out in the reverse order of removal.
Replacing the guides
1. Remove the hatch assembly.
2. By moving the slide (B) back, lower the guide assembly (A) as far as possible.
3. Remove the guide (A) and slide (B).
4. Installation is carried out in the reverse order of removal.
