Procedure
1. Move the selector lever to position N.
2. Loosen the control lever lock nut where the cable and lever connect.
3. Move the control lever to the N position.
4. Rotate the selector lever position indicator switch housing up to 12 mm and align the wide end of the control lever with the switch protrusion.
5. Tighten the switch mounting bolts to a tightening torque of 10–12 N·m.
Caution: When turning the switch housing, be careful not to damage the sealing ring.
6. Check that the selector lever is in position N.
7. Adjust the position of the nut so that there is no slack in the cable and the selector lever moves smoothly.
This article is based on information from the website (hyundaibook.ru)
8. Perform a test drive and ensure that the transmission is in the position corresponding to each selector lever position.