Rear wheel hub of a late model car
A - disc brake;
B - drum brake;
1 - fist;
2 - brake shield;
3 - hub;
4 - brake disc;
5 - washer;
6 - nut;
7 - cap;
8 - brake mechanism unit;
9 - hub;
10 - brake drum.
Loosen the mounting bolt and remove the rear wheel speed sensor (cars with ABS).
Disconnect the parking brake cable.
Remove the two bolts and remove the caliper assembly. Without disconnecting the brake hose from the caliper, use wire to tie the caliper to the body.
Remove the brake disc.
Loosen the screw and remove the brake drum.
Using a screwdriver, remove the hub cap.
After unscrewing the hub nut, remove the rear wheel hub assembly.
Replace the rear wheel hub assembly if the inner bearing race is worn.
Remove the wheel speed sensor rotor (cars with ABS).
If necessary, loosen the hub bolt.
Check the hub components for cracks and damage.
(The original material is located on the website: HyundaiBook.ru)
Installation
Installation is carried out in reverse order, taking into account the following:
Temporarily install the wheel speed sensor into the sensor bracket.
With the caliper and brake disc removed, insert the feeler gauge (2) into the gap between the rotor tooth and the pole of the wheel speed sensor (1), adjust the gap to a value of 0.3-0.9 mm and secure the sensor bracket.
Rear wheel hub components of single bearing car models
1 - suspension arm;
2 - bearing;
3 - toothed sector (models with ABS);
4 - nut.
