Contents: Removal ⇓ Installation ⇓
Anti-roll bar mounting elements
1 - stabilizer link;
2 - anti-roll bar;
3 - rubber bushings;
4 - clamps.
Removal
Loosen the nuts (1) and remove the anti-roll bar strut (2).
On some models, unscrew the nut at the top of the stabilizer link and remove the cup and rubber bushing, then remove the stabilizer link and remove the rubber bushing and cup from it.
Loosen the nuts (3) and remove the bracket (4) securing the stabilizer bushing.
After removing the bushing, remove the anti-roll bar.
Check the removed components for wear and damage.
Installation
Installation is carried out in reverse order, taking into account the following:
Since the positions of the right and left stabilizer bushing mounting brackets are different, install the stabilizer bar brackets in accordance with Figure XE 17.004.
Install the bushings (1) so that the colour marks protrude from the bushing by approximately 5 mm on the outside.
Check the rear wheel alignment angles.
[The original source of the article is the website hyundaibook.ru]