1. Clean all parts before assembly.
2. Check to make sure there are no blockages in the fuel and air passages.
3. Check the operation of the throttle actuator. If the actuator is jammed, clean the actuator parts (they can be replaced).
4. When replacing the main or auxiliary jets, the old and new jets must be the same size, since the selection of jets is carried out after precise measurements during selective assembly. •
5. Do not reuse O-rings in the gasket.
6. Make sure the correct size jets are installed in the correct position. Note that the size symbol is stamped on each jet for identification.
Identification tag
Main jet Engine 1.3 l:
- First - #87.5
- Second - #150
Auxiliary jet:
- First - #52.5
- Second - #52.5
