Note: If the low gear switch does not function properly, adjust it:
- included (ON) -1st or 3rd gear;
- switched off (OFF) - 2nd or 4th gear.
Checking the switch is described in the section «Checking the elements of the automatic transmission control system»
1. Completely remove debris around the switch adjusting screw.
2. Loosen locknut.
3. Loosen and tighten the adjusting screw (A) twice with a torque of 5 Nm.
4. Tighten the adjusting screw to 5 Nm, then loosen it 3-31/3 turns.
Note: Before assembling, apply sealant to the center of the adjusting screw.
5. Tighten locknut. Tightening torque: 15-22 Nm.