2. Before checking and installing the steering wheels, make sure that the wheels, steering and suspension are free of defects.
3. Measure the wheel alignment. Toe-in value: 0±2 mm.
4. Wheel alignment is adjusted by turning the adjusting nuts on the steering rod end.
5. Calculate the wheel alignment (B - A).
6. The transverse angle of the wheel pivot axis is not adjustable and is built into the design. The angle value is 0°±30'.
7. The longitudinal angle of the wheel turning axis is not adjustable and is built into the design. The angle is 3°32'±30'.
8. Measure the tire tread depth (A). The minimum allowable depth is 1.6 mm: the depth at which the tire wear indicator (B) is located.
9. If the tread height is less than the permissible value, replace the tire.
10. Measure the radial and axial runout of the disk. Permissible runout value: 0.3 mm.
The text is provided by the web resource: HyundaiBook
11. Install the wheel and tighten the mounting nuts in the sequence shown in the figure.
