Withdrawal
1. Pull and turn the cork handle to the right.
2. Remove the plug from the cap. After using the cork, turn the handle (–) to increase the gap between the cylinder head cover and the plug.
Installation
1. Lubricate the sealing ring of the plug with engine oil.
2. Insert the plug into the hole in the cylinder head cover and turn it to the left.
Attention! Always use new plugs when installing.
3. Using special tool 09351 - 27400, install the fuel injector oil seal.
4. Torque tighten the cap screws. Tightening torque: 8–10 Nm.