Withdrawal
1. Disconnect a wire from the negative plug of joint stock bank.
2. Loosen the three screws and remove the covers (1) steering column.
3. Disconnect the connector (2), depress the lock pin (3) and remove the left switch.
4. Disconnect the connector (4), depress the lock pin (5) and remove the right switch.
Installation
5. Installation is carried out in the reverse order of removal.
Checking the lighting control switch
6. Check the continuity of the circuit between the corresponding pins of the connector at different switch positions.
Light switch
Light switch
HU - high beam
HL-dipped beam
R - high beam signaling
Turn signal switch
Checking the wiper and washer control switch
7. Check the continuity of the circuit between the corresponding pins of the connector at different switch positions.
Windscreen wiper switch
Windshield washer switch
Rear window wiper and washer switch