1. Body (top part); 2. Housing (Bottom part); 3. Air inlet (left side); 4. Air inlet (right part); 5. Inlet damper; 6. Intake flap lever; 7. Intake damper drive; 8. Air filter cover; 9. Fan; 10. Power transistor (automatic control); 11. Fan resistor (manual control); 12. Seal; 13. Spacer; 14. Dust filter
Withdrawal
1. Disconnect a wire from the negative plug of joint stock bank.
2. Remove the instrument panel.
3. Disconnect the connectors of the intake damper actuator, fan motor and power transistor.
4. Remove a cross-beam of the panel of devices.
5. Unscrew the four screws and remove the fan (A) complete with air inlet and filter.
Installation
6. Installation is carried out in the reverse order of removal.