Checking the technical condition
1. Turn off the ignition.
2. Disconnect the purge control solenoid valve (PCSV) connector.
3. Measure the resistance between terminals 1 and 2 of the PCSV valve.
4. Check that the resistance matches the specification.
Removal
1. Turn the ignition key to the OFF position and disconnect the negative (-) cable from the battery.
2. Disconnect the purge control solenoid valve connector (A).
3. Disconnect the steam lines (B) from the purge control solenoid valve.
[This publication is based on information from the portal www.hyundaibook.ru]
4. Loosen the bracket mounting bolt (C) and then remove the valve from the smoothing receiver.
Installation
Attention.
- Tighten the component mounting bolts to the specified torque.
- Be careful not to drop the component. If dropped, the component must be carefully checked before installation.
- Do not allow foreign materials to enter the valve.
- Installation is performed in the reverse order of removal.
Note: Tightening torque: Purge control solenoid valve (PCSV) bracket mounting bolt: 9.8 - 11.8 Nm.