Petrol engine oil supply control valve (Hyundai Tucson LM)

Checking the technical condition

1. Turn off the ignition.

2. Disconnect the oil control valve (OCV) connector.

3. Measure the resistance between terminals 1 and 2 of the valve.

4. Check that the resistance matches the specification.

The original material is located on the website www.HyundaiBook.ru

Removal

1. Turn the ignition key to the OFF position and disconnect the negative (-) cable from the battery.

2. Disconnect the oil control valve connector (A).

3. Loosen the mounting bolt (B) and remove the valve.

Installation

Attention.

• Tighten the component mounting bolts to the specified torque.
• Be careful not to drop the component. If dropped, the component must be carefully checked before installation.
• Lubricate the valve seal ring with engine oil.
• Installation is performed in the reverse order of removal.

Note: Tightening torque: Oil control valve mounting bolt: 9.8 - 11.8 Nm.