2. Place the compressor in a vertical position and install the winding on the front head of the compressor. Check the correct position of the coupling winding connector.
3. Install the compression device on the compressor tip and in the center of the winding.
4. Install two 8-inch grippers on the compressor and compression device. The gripper legs must be deeply inserted behind the front seat of the compressor, and the bolt must be located in the center of the compression device.
5. Rotate the bolt with a wrench to securely press the winding onto the front head of the compressor.
6. Install the clutch pulley and hubs onto the compressor.
7. Clean the pulley surface from dirt and rust.
8. Install the pulley with bearing on the compressor shaft.
9. Install the retaining ring.
10. Insert a washer of the required size into the groove of the sleeve and put the sleeve on the pulley shaft.
11. Tighten the mounting bolt at the end of the shaft to a torque of 10-15 Nm.
[The article is borrowed from an online resource HyundaiBook]