1. Use a special tool to loosen the mounting bolt.
2. Remove the bushing and gasket from the compressor shaft. If the bushing is difficult to remove, screw an 8 mm bolt into the bushing hole and remove the bushing from the shaft.
3. Remove the retaining ring.
4. Remove the pulley with the bearing from the shaft.
5. Install a shaft protection device into the compressor bore.
6. Install the pulley on the compressor shaft. Install the end of the puller bolt into the concave central part of the shaft protection device, insert the puller jaws under the winding collar.
7. Press the winding by rotating the puller bolt.
8. Remove the clutch winding from the compressor.
