Removal and installation
1. Remove the screw securing the inner handle and remove it from the door trim.
2. Remove the screws securing the door trim.
3. Insert the door trim remover between the door trim and the door and release the clips. Disconnect the electrical connectors.
4. Remove the speaker and moisture-proof film from the front door.
5. Lower the door glass down and remove the glass mounting screws.
6. Remove the glass from the front door.
7. Remove the door glass guide.
8. Remove the rear channel from the door.
9. Remove the bolts securing the outer door handle, the lock and the lock drive. Disconnect the connectors from the front door control unit.
 |
 |
10. Remove the control unit from the front door.
11. Remove the outside rearview mirror.
Installation is carried out in the reverse order of removal. When installing the moisture-proof film, the holes for the door trim fasteners must not be covered.
Adjusting the door position
Check that the door closes easily and properly. If the door has play, tighten the door hinge mounting bolts.
Warning: Attach protective tape to the edges of the wing opposite the door hinge.
Door strike plate
Check that the door closes easily and properly. If necessary, adjust the door as follows.
1. If the door lock is installed on the strike plate with difficulty, unscrew the strike plate mounting screws and, by moving it in horizontal and vertical planes, achieve normal door closing.
2. Adjust the position of the door relative to adjacent surfaces by moving the strike plate in the vertical plane.
Caution! To check the smoothness of the impact plate fit, pull the outer door handle outward and in this position press the door to the closing position.