Contents: Removal ⇓ Installation ⇓
Air Conditioning Compressor Elements
1 – compressor with clutch; 2 – compressor; 3 – cylinder and shaft; 4 – front cylinder; 5 – rear cylinder; 6 – bushing; 7 – bearing ring A; 8 – bearing; 9 – L bearing ring; 10 – disk installed at an angle to the shaft; 11 – shaft; 12 – shoe; 13 – piston; 14 – bearing ring E; 15 – spring; 16 – input plate; 17 – Front plate block; 18 – front plate; 19 – hairpin; 20 – Back plate block; 21 – back plate; 22 – unloading element; 23 – front gasket; 24 – rear gasket; 25 – sealing ring; 26 – rear section of the compressor; 27 – front section of the compressor; 28 – bolt; 29 – flat washer; 30 – shaft seal; 31 – ring; 32–1 – compaction; 32–2 – mounting sleeve; 32–3 – mounting sleeve; 33 – excitation coil; 34 – pulley; 35 – disk and hub; 36 – ring; 37 – gasket; 38 – bolt; 39 – screw; 40 – connector bracket; 41 – collector unit; 42 – collector; 43 – suction pipe; 44 – discharge pipe; 45 – safety valve; 46 – O-ring seal round section; 47 – hairpin; 48 – bolt; 49 – spanner; 50 – gasket

Removal

(The basis of the material is information from the website HYUNDAIBOOK.RU)
1. Loosen and remove the air conditioning compressor drive belt.

2. Discharge the air conditioning system.

3. Remove the discharge hose and suction hose.
4. Remove the air conditioning compressor. Immediately close all open holes and tubes to prevent moisture from entering the air conditioning system.
Installation
5. Installation is carried out in the reverse order of removal.
