Gearbox oil change
After carefully inspecting all parts, check for any signs of leakage. Remove the filler plug and check the oil level. If the oil becomes contaminated, it must be replaced.
1. Remove the filler plug and check the oil level.
2. The oil level should reach the filler hole. If the level is lower, add oil and replace the plug.
3. If the oil appears dirty and its viscosity does not meet requirements, the oil must be changed.
Use hypoid gear oil SAE 75W/85W (API-GL 4)
4. Place the vehicle on a level surface, remove the drain plug and drain the transmission oil.
5. Replace the gasket with a new one and install the drain plug in its place.
6. Fill with new oil through the filler hole to a level 5-9 mm below the hole.
Full capacity - 2.15 l
Replacing the drive shaft seal
1. Disconnect the drive shaft from the gearbox.
2. Using a flat-blade screwdriver, remove the oil seal.
3. Using a special tool (09431-21200), install the input shaft seal into the gearbox.
4. Apply a layer of gear oil to the oil seal working surface.
Manual Transmission Oil: SAE 75W/89W hypoid transmission oil meeting API GL 4 or higher standard.