Contents: Adjustment ⇓ Replacing lamps ⇓
Adjustment
Measure the center of the fog light as shown in the illustration.
Set the distance from the centres of the fog lights to the screen (1) to 5 m as shown in the figure.
Adjust the tire pressure to the nominal value and leave only the driver in the car, or place a load of about 75 kg in his place.
Set the engine speed to 2000 rpm and adjust the front fog light beam.
Check that the position of the light beam on the screen corresponds to the nominal value. Nominal dimensions:
- vertically - 100 mm below the horizontal line (H);
- horizontally - parallel to the direction of vehicle movement.
If necessary, make adjustments by turning the adjusting screw (1).
Replacing lamps
Remove the fog lamp cover.
Disconnect the connector that is attached to the fog lamp bracket as shown in the figure.
Remove the bolts and remove the fog lamp assembly.
Remove the rear fog light cover.
Unfasten the spring that holds the lamp in place and then replace it.
1 - spring;
2 - rear cover of the fog lamp.