1. Lever and wiper blade
2. Nut
3. Lid
4. Washer
5. Wiper motor assembly
Withdrawal
1. Remove the liftgate trim.
2. Remove the cover (1), unscrew the nut (2) and remove the wiper arm. Tightening torque: 10-13 Nm.
3. Remove the cover, unscrew the nut (3) and remove the puck (4). Tightening torque: 10-13 Nm.
Note: when installing, the mark on the washer must be at the top.
4. Disconnect the connector, unscrew the two screws and remove the motor.
Installation
5. Installation is carried out in the reverse order of removal.
Adjustment
6. The initial position of the wiper blade is 36 mm up from the lower current-carrying strip of the rear window heating element.
7. Adjust the position of the windshield washer nozzles in accordance with the indicated dimensions (mm).