Contents: Hatch tilt ⇓ Closing the hatch ⇓ Removal the hatch ⇓ Installing a hatch ⇓ Storing the sunroof and sunshade ⇓
Hatch tilt
The hatch can be opened and closed manually.
1. Pull the handle down and then forward and up as shown by the arrows in the figure.
2. Press the center of the handle to lock the hatch in the open position.
3. After tilting the hatch, make sure the handle is locked in place.
Closing the hatch
1. Pull the handle towards you.
2. After the hatch has been closed, lock the handle in place.
3. Make sure the hatch and handle are securely closed.
Warning: Do not open the sunroof if the outside temperature is very low or if it is covered with ice or snow.
Warning: Before opening the hatch, remove any water droplets, snow, ice or sand from it.
Removal the hatch
1. Before removing the sunroof, remove the sunshade.
2. Pull the handle down completely.
3. Press the handles at the base until they come out of their holes.
Directions for pressing the handles at the base of the handle to remove them from the holes when removing the hatch.
4. Raise the sunroof glass from the outside of the vehicle until it is perpendicular to the roof panel.
Raising the hatch when removing it from the vehicle.
5. Remove the sunroof from the roof panel.
Installing a hatch
1. Insert the flat tabs into the slots. Then, supporting the hatch with your hands, slowly lower it.
Places for installing flat tabs in slots when installing the sunroof on a car.
2. Make sure both tabs are securely locked into the slots.
3. Press the handles on the base and insert them into the holes.
Warning: Do not attempt to install or remove the sunroof while the vehicle is moving.
Warning! Do not drive unless you are sure that the hatch is securely fastened.
Storing the sunroof and sunshade
There is a sunroof storage bag in the luggage compartment. Place the sunroof or sunshade in the bag and store it in the trunk.
Warning: When storing the sunroof and sunshade in a bag, place the sunshade on top of the sunroof.