Contents: Sun protection blind ⇓ Opening and closing the hatch ⇓ Hatch tilt ⇓ Manual hatch drive ⇓ Resetting the sunroof electric drive ⇓
Sun protection blind

Your Hyundai vehicle is equipped with a sliding sunshade that you can manually adjust to allow light to pass through the closed sunroof.
Warning: Never adjust the sunshade while the vehicle is moving.
Opening and closing the hatch
1 - "Open"
2 - "Close"
The sunroof can only be operated when the ignition key is in the "ON" position. The sunroof will be fully opened by pressing the "OPEN" button, and to stop the sunroof in the desired position, press one of the buttons ("OPEN", "CLOSE", "Up", "Down"). To close the sunroof, press and hold the "CLOSE" button. Release the button when the sunroof reaches the desired position.
Warning:
- Do not close the sunroof if anyone's hands, shoulders or other body parts are between the sunroof cover and the edge of the sunroof, as this may result in injury.
- Do not stand or extend your head or arms into the hatch opening.
Attention:
- Do not open the sunroof if the outside temperature is very low or if it is covered with ice or snow.
- Periodically remove any dirt that accumulates on the sunroof guides.
Hatch tilt
1 - "Up"
2 - "Down"
The sunroof will tilt completely when you press the "Up" button, and to stop the sunroof in the desired position, you need to press one of the buttons ("OPEN", "CLOSE", "Up", "Down"). To close the sunroof, press and hold the "Down" button. Release the button when the sunroof reaches the desired position.
Note: After rain or washing your car, remove any remaining water from the sunroof before opening it.
Manual hatch drive
If the electric sunroof drive does not work:

1. Remove the cover located in the rear roof panel using a coin or screwdriver.

2. Insert the Allen key provided in the vehicle into the socket. This key is located in the trunk of the vehicle or in the glove compartment.
3. To open the hatch, turn the key counterclockwise, and to close it, turn it clockwise.
Resetting the sunroof electric drive
After the battery has been discharged, disconnected, the sunroof has been moved manually using a hex key, or if the sunroof movement has been interrupted by turning off the ignition, it may be necessary to reset the sunroof electric drive.
To do this:
- 1. Turn off the ignition.
- 2. Simultaneously press the "OPEN" and "Up" buttons to turn on the ignition.
- 3. After such a reset of the sunroof electric drive, the sunroof will be tilted up and down once to automatically reset all extreme positions.
Caution: If the sunroof drive is not reset, it may not operate properly.
