Execution order
1. Remove the anti-roll bar link.
2. Check the torque required to turn the stabilizer link ball joint pin.
If there are cracks in the protective boot, replace it and add grease to the joint.
Rock the stabilizer link ball joint pin from side to side several times.
Screw the self-locking nut onto the ball joint pin and measure the torque.
Torque: 1.7–3.2 Nm
If the torque exceeds the permissible values, replace the stabilizer link.
If the torque is significantly below the permissible value, the ball joint can be used repeatedly as long as it does not jam or have excessive play.
3. Install the stabilizer rod and secure it with a nut so that the lower nut is located at a distance A from the end of the rod.
Distance (A) from the end of the stabilizer rod to the nut: 4–6 mm