Removal
1. Remove the brake light switch.
2. Remove the cotter pin and remove the pin with the head and hole for the cotter pin.
3. Unscrew the flange nuts securing the brake pedal bracket.
4. Remove the brake pedal assembly.
Examination
1. Check the bushing for wear.
2. Check the brake pedal for warping.
3. Check the brake pedal return spring for damage.
4. Check the brake light switch
- 1) Using an ohmmeter connected to the terminals of the brake light switch, check its conductivity.
- 2) When the plunger is pressed, conductivity should be absent and appear when the plunger is released.
Installation
Installation is carried out in the reverse order of removal.
Caution: Make sure to install the cotter pin on the brake pedal linkage head and cotter pin hole.
The text is provided by the web resource [HyundaiBook.ru]
1. Install the brake pedal assembly and secure with flange nuts and bolt. Tightening torque: 13–16 Nm.
2. Check and, if necessary, adjust the pedal height and free travel of the brake pedal.
3. Install the brake light switch.