Doors - Position adjustment
If the gap between the door and the body is uneven, then stick protective tape on the surface where the door meets and the surface around the door hinge on the body. Then, using a special tool, loosen the bolts securing the door hinge to the body and adjust the gap between the door and the body.
If the closed door is not flush with the body surface, use a special tool to adjust its position after loosening the bolts securing the door hinges to the body.
If the door is difficult to open and close, adjust the position of the lock and latch by adjusting the latch.
Window lifter safety mechanism - check
Lower the door glass 50 mm from the fully closed position.
Place a wooden board about 4mm or less thick as shown in the picture and lift the glass.
Check that when the board is clamped, the glass automatically drops by approximately 50 mm.
Lower the glass again 50 mm or more from the fully closed position and repeat the test. Make sure that this time the glass goes down approximately 150 mm.
Replace the window regulator assembly if the door glass does not move the specified distances.
When installing a new window regulator, for all doors, after the door windows are completely closed, hold the window control switch in the "UP" position for one second or longer.