Separate the adhesive joint with a nylon cord, for convenience, heat the molding with a hair dryer to 40°C.
Treat the bonding area on the body with gasoline. Remove the protective film from the marked areas. When installing old molding, remove any remaining adhesive with gasoline and apply 1mm thick, 5mm wide double-sided adhesive tape to the marked areas. After heating the molding and the body to a temperature of 40° to 80°C, press the molding to the body.
Press the palm of your hand into the middle to snap each clip (if any).
(This publication is based on information from the portal: «HYUNDAIBOOK.RU»)