Removal and installation the side protective molding (Hyundai Sonata EF)

0

1. Using the special tool, remove the side protective molding of the front side door or rear side door.

Caution: Be careful not to scratch or deform the door molding.

Caution: Be careful not to scratch or deform the door molding.

2. Properly install the molding inside the gap as shown in the figure and fasten it firmly.

2. Properly install the molding inside the gap as shown in the figure and…

(Information is taken from a thematic website: www.hyundaibook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Previous

Sonata 4: Exterior

Next

Rear side door
Front side door
Trunk lid — removal and installation
Hood — adjustment
Troubleshooting by their symptoms

Sunroof — Removal, Assembly and Installation
Side rear view mirror
Front bumper
Rear bumper

We recommend other articles on the topic of Hyundai manuals:

Removal and installation protective molding Hyundai Accent 3 (2005-2010)
Side molding — removal and installation Hyundai Elantra 1 (1990-1995, petrol)
Replacing the ball joint and protective cover of the front… Hyundai Getz (2002-2011)
Side deflector Hyundai Santa Fe 2 (2007-2012, petrol)
Side airbag sensor Hyundai Tucson 1 (2005-2010)
Side impact sensor Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet

This site uses cookies to optimize its functionality. By continuing, you agree to our terms.