Automatic transmission F4A33 Hyundai Sonata 3

Technical characteristics of automatic transmission
Type - Automatic four-speed with torque converter and differential F4A33 Torque converter: Type - With damper coupling Lock rotation frequency - 2200-2500 rpm Torque...

Lubricants and fluids

Tightening torque
Tightening torque, Nm Air filter bolt - 8-10 Thrust to the cam - 24-34 Lower arm joint to cam - 60-72 Bracket for automatic transmission - 60-80 Automatic transmission -...

Checking the working fluid level
1. Place the car on a level surface. 2. Before using the dipstick, wipe off all dirt from the areas around it. 3. With the gear shift lever in place and the parking...

Diagnostic Trouble Codes
Troubleshooting Tips see chapter 9 .

Adjusting the manual control cable
The adjustment of the cable of such a drive can be checked as follows. 1. Apply the brakes and parking brake. 2. Place the gear shift lever in the "R" position. 3. Turn...

Displaying diagnostic trouble codes
1. Connect a voltmeter or scanning device to the connector. 2. Read the output diagnostic trouble codes. Then follow the troubleshooting procedure in the Diagnostic...

Two vehicle movement programs
Two vehicle driving programs are stored in the control unit memory: in "powerful" mode and in "economical" mode. The driver can select the mode using the Power/Normal...

Checking oil pressure
1. Warm up the automatic transmission. 2. Raise the front of the vehicle so that the front wheels can turn. 3. Connect the tachometer to the engine, placing it where it...

Seals — Description and Location

Torque Converter Lockup Test
The test consists of determining the critical engine speed with the throttle fully open and the automatic transmission lever in position "D" or "R". The operation of the...

Four-speed automatic transmission check and adjustment
Name Symbol Throttle position sensor A Pulse generator A IN Pulse generator B IN Solenoid valve connector WITH Oil temperature sensor D Name Symbol 4-speed automatic...

Checking the working fluid level
1. Place the car on a level surface. 2. Before using the level gauge, wipe off any dirt from the areas around it. 3. With the gearshift lever in position "P" (park) and...

Adjusting the automatic transmission shift cable
1. Place the gear shift lever in "N" (neutral). 2. Loosen the manual control lever control cable. Disconnect the cable and the lever. 3. Set the manual control lever to...

Servo drive adjustment
1. Remove dust, dirt, etc. completely from and around the servo cover. 2. Press the spring retaining ring and remove the switch. 3. Insert the special tool into the...

Adjusting the pressure in the system
1. Drain the transmission fluid. 2. Remove the oil pan and oil filter. 3. Remove the oil temperature sensor. 4. Press the tab of the solenoid valve harness bushing and...

Management of the agro-industrial complex

Gear shift lever

Automatic transmission — removal and installation
Removal and installation The operations for removing and installing the automatic transmission are similar to those given in the relevant section of Chapter 9 . Bolt Nm...
There is 1 a comment

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Add to social network:

Link in different formats to this section

TextHTMLBB Code