2. Loosen the manual control lever control cable. Disconnect the cable and the lever.
3. Set the manual control lever to "N".
4. Turn and position the switch housing so that the hole at the end of the manual control lever and the hole (section A-A in the figure) on its flange coincide.
5. Tighten the connecting bolts (2 pcs.) carefully so that the switch housing is motionless.
6. Make sure that the gear shift lever is in the "N" position.
7. Take up any slack in the control cable by adjusting the nut, then make sure that the lever moves smoothly without interference.
8. Make sure the control cable is adjusted correctly.