2.0 liter I4 DOHC engine Hyundai Sonata 3

Engine with two overhead camshafts-technical specifications
Technical specifications Nominal value Limit value Engine type In-line, with two overhead camshafts Number of cylinders 4 Cylinder diameter 85 mm Piston stroke 88 mm...

Tightening torque
Engine Mount Bracket Nut and Bolt - 50-65 Connecting the high pressure fuel hose to the fuel line - 4-6 Accelerator cable adjusting bolt - 4-6 Front Engine Bracket Bolt...

Compression test (2.0L engine)
1. Before checking the compression, you should check the engine oil level. 2. Turn off the engine and wait until the engine coolant temperature reaches 80-95°C. 3. Start...

Adjusting the tension of drive belts
1. Check the serviceability of the belts and their alignment with the pulley grooves. 2. Apply a force of 100 N to the outer side of the drive belt at the center between...

Engine Installation — Components

Engine and gearbox assembly — removal and installation
Removal 1. Remove the battery. 2. Disconnect the air cleaner. 3. Disconnect the reversing light connectors and engine compartment wiring. 4. For a vehicle with a...

Timing Belt — Components

Timing Belt — Removal
Removal 1. Remove the crankshaft and engine coolant pump pulleys, then remove the drive belt. 2. Remove the timing belt covers. 3. Turn the crankshaft clockwise and...

Toothed Belt — Checking and Installing
1. Check the camshaft and crankshaft gears, as well as the tension and guide rollers, for wear, cracks and damage. Replace them if necessary. 2. Check the ease and...

Camshafts and rocker arms — components

Camshafts and rocker arms — removal and installation
Removal 1. Disconnect the negative battery terminal. 2. Drain the coolant from the engine. 3. Remove the suction hose between the air cleaner and the valve cover. 4....

Cylinder head and valves — components

Cylinder head and valves — removal and installation
Removal 1. Using a special tool, a cylinder head bolt wrench (09221—32001), unscrew the cylinder head mounting bolts as shown in the figure. 2. Using a special tool, a...

Front cover, oil pump and balance shafts — components

Front Cover, Oil Pump and Balance Shafts — Removal and Installation
Removal 1. Remove the timing belt. 2. Remove all oil pan bolts. 3. Remove the oil pan. 4. Remove the oil receiver and gasket. 5. Remove the plunger and gasket, then...

Piston and connecting rod — components

Piston and connecting rod — removal and installation
Removal Connecting rod lower head cover Note: Keep the bearing shells in connecting rod numbering order (corresponding to cylinder numbering) for later installation. 1....

Crankshaft, flywheel — components

Crankshaft, flywheel — removal and installation
Removal 1. Remove the timing belt drive gears, front cover, flywheel cylinder head and oil pan (refer to the relevant sections for instructions). 2. Remove the rear...

Cylinder Block — Components

Cylinder Block — Removal and Installation
Removal Remove the cylinder head, belt drive wheels, front cover, flywheel, pistons and crankshaft (refer to the appropriate sections). Examination Cylinder block 1....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Power unit: DOHC engines Hyundai Accent 1 (1994-1999)
Power unit: Engine repair 1.5/1.6 l Hyundai Getz (2002-2011)

Add to social network:

Link in different formats to this section

TextHTMLBB Code