The cable adjustment of such a drive can be checked as follows.
1. Apply brakes and parking brake.
2. Put the gear lever in position «R».
3. Turn the ignition key to position «ST» (start).
4. Slowly move the shift lever up until it clicks into place «R» (parking). If the starter is running when this lever is locked, the position «R» correct.
5. Then, in the same order, slowly move the shift lever to the position «N» (neutral).
If the starter operates when the lever enters this position, then this position is correct.
6. Verify that the vehicle is not moving and that the lever does not stop between PRND positions.
7. The hand control cable is properly adjusted if, as described above, the starter operates as in position «R», and in position «N».