Removal and installation the spring (Hyundai Accent MC)

Removal

1. Remove the rear wheel. Tightening torque of the nuts: 90-110 Nm.

2. Loosen the screws of the wheel speed sensor bracket (1) and the brake hose (2). Tightening torque: 7-11 Nm (screw 1), 9-14 Nm (screw 2).

Caution: When lowering the rear suspension beam, make sure that the brake hose is not stretched.

3. Support the torsion beam with a jack and unscrew the screw (3) of the lower shock absorber mount. Tightening torque: 100-120 Nm.



[This publication is based on information from the portal: hyundaibook.ru]



4. Remove the spring (4).

Installation

5. Installation is performed in the reverse order of removal.

Note: When installing, align the grooves of the cushions with the ends of the spring.