Contents: Removal ⇓ Installation ⇓
Removal
1. Remove the rear wheel. Tightening torque of the nuts: 90-110 Nm.
2. Remove the brake caliper and brake disc.
3. Remove the rear wheel hub assembly (2).
4. Remove the shoe support pin (3) together with the spring (4) by pressing the spring and turning the pin.
5. Remove the clearance adjuster (5) and the lower tension spring (6).
6. Disconnect the parking brake cable (7) from the brake shoe (8).
7. Remove the expansion bar (9) and the upper tension springs (10).
The full version is located on the website [HyundaiBook]
8. Remove the brake shoe.
Installation
9. Install the pads (11) on the brake shield (12). Install the support pin (13) with the spring (14).
10. Install the expansion bar (15) and upper tension springs (16). Install the regulator (17) and lower tension spring (18).
11. Apply grease to the sliding surfaces of the brake mechanism. Do not apply grease to the friction linings of the shoes.
12. Install the brake disc and caliper.
13. Adjust the parking brake lever.