1 – fan motor cooling tube; 2 - block of resistors; 3 - air intake; 4 - air intake damper shaft; 5 - upper fan case; 6 - lower fan case; 7 - fan impeller; 8 - fan motor; 9 - fan motor cover.
Withdrawal
1. Remove the instrument panel.
2. Disconnect the connectors from the fan motor and resistor pack.
3. Turn out nuts and remove the block of the evaporator.
4. Remove 3 nuts (or bolts) fan bracket mounting.
5. Remove the fan assembly.
Installation
6. Installation is carried out in the reverse order of removal.
Withdrawal
1. Disconnect the fan motor cooling tube.
2. Remove the three screws and remove the fan motor.
3. Release the clips securing the air intake to the upper fan housing.
4. Remove the air intake.
5. Use a flathead screwdriver to release the six tabs and separate the top and bottom fan cases.
6. Loosen the two screws and remove the fan resistor.
7. Assembly is carried out in the reverse order of disassembly.
Checking the fan motor
With additional wires, apply voltage from the battery to the contacts and connector of the fan motor. If the fan motor is spinning, then it is good.