Contents: Removal ⇓ Installation ⇓
Removal
1. Turn the ignition key to the "OFF" position and disconnect the negative (-) cable from the battery.
2. Disconnect the boost pressure sensor connector (A).
3. Loosen the mounting screws and remove the boost pressure sensor (B).
Installation
Attention.
- Tighten the component mounting bolts to the specified torque.
- Be careful not to drop the component. If dropped, the component must be carefully checked before installation.
Installation is performed in the reverse order of removal.
Note: Boost pressure sensor mounting bolt: 9.8 - 11.8 Nm.