2. Remove the side cover (A) of the instrument panel.
3. Remove the cover (A).
4. Remove the lower cover (A) of the instrument panel.
5. Disconnect the diagnostic connector (A).
6. Remove the reinforcement panel (A).
[Original version of the article on the website HYUNDAIBOOK.ru]
7. Remove the condensate pipe (A).
8. Disconnect the temperature control actuator connector (A).
9. Loosen the mounting screws and remove the temperature control drive (B).
From the driver's side
10. Remove the cover on the right (A).
11. Disconnect the damper (A) from the glove box (B).
12. Remove the glove box lifting mechanism (C).
13. Disconnect the pin and remove the glove box (A).
14. Remove the instrument panel section (A) from the passenger side.
15. Remove the glove box housing (A).
16. Remove the condensate pipe (A).
17. Disconnect the temperature control actuator connector (A).
18. Loosen the mounting screws and remove the temperature control drive (B).
From the passenger side
19. Installation is carried out in the reverse order of removal.